nanoHUB could be intermittently unavailable on 05/04 from 8:00 am – 1:00 pm (EST) for scheduled maintenance. All tool sessions will expire on 05/04 at 8:00 am (EST). We apologize for any inconveniences.
Find information on common issues.
Ask questions and find answers from other users.
Suggest a new site feature or improvement.
Check on status of your tickets.
Boundary conditions for the potential equation
Open | Responses: 1
I would like to know what are the boundary conditions for the potential equation. I assume the boundary condition at the gate is the prescribed V_g. Are the rest of the boundaries assigned...
Coupled Mode Space
Closed | Responses: 2
The results obtained using the 2 transport models supported in the tool gives exactly the same results for different nanowire diameters and i noticed that when choosing the...
defining the 3D electron density
Open | Responses: 2
In the reference cited, Nanowire uses the NEGF formalism and the 3D density is expressed in terms of that formalism. Could someone tell me what the equation will be like in terms of...
In determining the density of the electrons, what fermi level do you used? Do you assume a value or do you calculate it at every iteration?
Getting Exit Code 1
Closed | Responses: 1
Why is this problem happening??
Program Finished :Exit Code is 1
Can’t read “total_vstep” :no such variable
input deck of the nanwire simulation
Closed | Responses: 0
Could I have input deck of the nanwire simulation for using it in NEMO 5? I want to do some changes in the nanowire geometry.
Thanks in advance.
Is it possible to dope the nanowire n-type at the source end and p-type at the drain end using this tool?
Is the poisson equation in the iterative scheme altered in the same manner as NanoMOS?
To improve convergence, the poisson equation in NanoMOS was altered to include a quasi-fermi potential term....
Is the tool running now? I can’t seem to even launch it. Before this, there was an error with MPI that I could not proceed.
Matlab Code Nanowire
Kindly send me the Matlab code of this tool/nanowire.
1. in nanowire tool if we choose materail Ge, or GaAs or http://nanohub.org/answers/question/1027
sir how to see netlist after device simulation??
not converging to the default tolerance
I simulate a case where Vg = 0.4V and Vd = 0.0V. The rest of the parameters are the defaults value. I am using uncoupled mode with average onto a single slice. The solution did not converge...
Problem during simulation
when I am using Nanowire Tool,during simulation it summit my job with an id but it shows that no environment’site match for your job.It happens from last 2days.How to solve this problem.
The tool is not running.
while running any simulation, the job shows completed simulation message. but there is no graph other than meshing. there are some output logs with every gate voltage which shows some error....
tool is not giving results it is taking more than 3 hours even for uncoupled mode case and then show error.
Want to find out capability
Hi. I need to run some simulations for a Nanowire-on-Insulator Mosfet. I wanted to know if i could simulate it using this tool? If yes, is there a example created for a NOI? Thnx in advance