1 | /* -*- mode: c++; c-basic-offset: 4; indent-tabs-mode: nil -*- */ |
---|
2 | /* |
---|
3 | * ---------------------------------------------------------------------- |
---|
4 | * Nanovis: Visualization of Nanoelectronics Data |
---|
5 | * |
---|
6 | * ====================================================================== |
---|
7 | * AUTHOR: Wei Qiao <qiaow@purdue.edu> |
---|
8 | * Purdue Rendering and Perceptualization Lab (PURPL) |
---|
9 | * |
---|
10 | * Copyright (c) 2004-2006 Purdue Research Foundation |
---|
11 | * |
---|
12 | * See the file "license.terms" for information on usage and |
---|
13 | * redistribution of this file, and for a DISCLAIMER OF ALL WARRANTIES. |
---|
14 | * ====================================================================== |
---|
15 | */ |
---|
16 | |
---|
17 | #ifndef CONFIG_H__ |
---|
18 | #define CONFIG_H__ |
---|
19 | |
---|
20 | #define NV40 /* Uncomment if using 6 series |
---|
21 | * card. By default we assume older |
---|
22 | * card the 5xxx series */ |
---|
23 | #define XINETD /* Enable render server. */ |
---|
24 | //#define EVENTLOG /* Enable event logging. */ |
---|
25 | //#define DO_RLE /* Do run length compression. */ |
---|
26 | |
---|
27 | /* |
---|
28 | * Controls if debug trace logging is enabled |
---|
29 | */ |
---|
30 | //#define WANT_TRACE |
---|
31 | |
---|
32 | /* |
---|
33 | * The following define controls whether new prototype features are to be |
---|
34 | * compiled. Right now by default it's off (0). That's because nanovis |
---|
35 | * releases are built directly from the subversion repository. So for now, |
---|
36 | * we'll rely on developers to set this in their respective sandboxes. |
---|
37 | */ |
---|
38 | #define PROTOTYPE 0 |
---|
39 | |
---|
40 | /* |
---|
41 | * The following define controls whether new load_volume_stream or |
---|
42 | * load_volume_stream2 are used to load DX data. The difference is that |
---|
43 | * load_volume_stream2 doesn't do any interpolation of the points to a coarser |
---|
44 | * mesh. Right now, we're using load_volume_stream2 to make isosurfaces |
---|
45 | * work correctly. |
---|
46 | |
---|
47 | * [In the future, we'll use the OpenDX library reader and determine at |
---|
48 | * runtime if mesh decimation is required] |
---|
49 | */ |
---|
50 | #define ISO_TEST 0 |
---|
51 | |
---|
52 | /* |
---|
53 | * The following define controls whether the plane* commands are |
---|
54 | * registered in the interpreter. Right now it's off. [Are these |
---|
55 | * commands still required?] |
---|
56 | */ |
---|
57 | #define PLANE_CMD 0 |
---|
58 | |
---|
59 | #endif |
---|