Thermophotonic Selective Emitter Simulation

By Anubha Mathur1, Enas Sakr, Peter Bermel1

1. Purdue University

Simulate Thermophotovoltaics With Rare Earth-Based Selective Emitters

Launch Tool

You must login before you can run this tool.

Version 2.0 - published on 13 Jan 2015

doi:10.4231/D3S17ST4G cite this

Open source: license | download

View All Supporting Documents

    Thermophotonic Selective Emitter Simulation tool image 1 Thermophotonic Selective Emitter Simulation tool image 2



Published on


Thermophotovoltaic (TPV) devices convert heat to electricity using thermal radiation to illuminate a photovoltaic (PV) diode. Typically, this radiation is generated by a blackbody-like emitter. Such an emission spectrum includes a broad range of wavelengths, but only higher energy photons can be converted by the PV diode, which severely limits efficiencies. Thus, introducing a selective emitter and filter to recycle unwanted photons could potentially greatly enhance performance. In this work, we consider a rare earth-doped selective emitter structure to increase the number of photons emitted above the bandgap of the photovoltaic (PV) cell, while minimizing the total power emitted below the bandgap. A chirped dielectric stack, as shown in the figure  is introduced on top to limit emitted wavelengths, while a broadband dielectric mirror on the bottom ensures unidirectional emission. We developed a GUI-based tool to precisely calculate the emittance spectrum and efficiency for this design as various parameters, such as the number of dielectric bilayers and PV cell bandgap. Through simulations of chirped dielectric  stack structures and coatings on a rare-earth ceramic substrate, it is found that an efficiency of 33.89% is achievable, for a filter bandgap of 0.37 eV and PV bandgap of 0.75 eV. The research thus demonstrates the potential for unprecedented efficiencies of TPV cells. These predictions will be used to experimentally fabricate and characterize these structures.

Cite this work

Researchers should cite this work as follows:

  • Anubha Mathur, Enas Sakr, Peter Bermel (2015), "Thermophotonic Selective Emitter Simulation," (DOI: 10.4231/D3S17ST4G).

    BibTex | EndNote